Cisco PowerKEY CableCARD Module 802 Installation Guide
Chapter 2 PCG Hardware
14
78-4017672-01 Rev E
PCG System Setup
Mount the PCG into the network per the hardware provider's instructions. Set up
the PCG with the appropriate peripherals and connect it to the appropriate
networks.
the PCG with the appropriate peripherals and connect it to the appropriate
networks.
Note: The keyboard, video and mouse are only required for initial setup.
1 Connect a monitor using the VGA connection.
2 Connect a USB or PS/2 keyboard and mouse to the rear of the server.
3 Attach a network cable (CAT5 or better) to Gigabit port 0 (see illustration below).
1 Connect a monitor using the VGA connection.
2 Connect a USB or PS/2 keyboard and mouse to the rear of the server.
3 Attach a network cable (CAT5 or better) to Gigabit port 0 (see illustration below).
This connection should be on the DNCS/ISDS network.
Important: Some servers label the Gigabit ports 1 and 2 rather than 0 and 1.
Please follow the conventions of your particular hardware device.
Important: Some servers label the Gigabit ports 1 and 2 rather than 0 and 1.
Please follow the conventions of your particular hardware device.
4 Attach a network cable (CAT5 or better) to Gigabit port 1(see illustration below).
This connection should be on the SCS network.
5 Attach the power cord to the rear of the server and to (North American)
120V/60Hz electrical power or (International) 220V/50Hz electrical power.