Cisco PowerKEY CableCARD Module 802 Installation Guide
Chapter 3 Install the PCG Software
18
78-4017672-01 Rev E
Installing the PCG Application Software
Complete the following steps to install the PCG Application Software from CD.
1 Open an xterm window on the DNCS/ISDS.
2 Press the CD eject button to open the drive. Place the PCG Application CD into
1 Open an xterm window on the DNCS/ISDS.
2 Press the CD eject button to open the drive. Place the PCG Application CD into
the drive tray on the DNCS/ISDS and close the tray.
3 Type su - and provide the root password at the prompt.
4 Type cd /cdrom/cdrom0
5 Type install_pkg
6 At the prompt, type yes to install the package.
7 When the install is complete, type cd and press Enter.
8 Type the following: eject cd
9 Type exit and press Enter to log out as the root user.
10 Verify that the PCG installation was successful by validating the release
4 Type cd /cdrom/cdrom0
5 Type install_pkg
6 At the prompt, type yes to install the package.
7 When the install is complete, type cd and press Enter.
8 Type the following: eject cd
9 Type exit and press Enter to log out as the root user.
10 Verify that the PCG installation was successful by validating the release
information. Type the following:
pkginfo -l SAIpcg
The example below depicts the application software is running at version level
2.0.0.9:
pkginfo -l SAIpcg
The example below depicts the application software is running at version level
2.0.0.9:
PKGINST: SAIpcg
NAME: PowerKEY CAS Gateway 03-05-09
CATEGORY: application
ARCH: sparc
VERSION: V2.0.0.9
BASEDIR: /
VENDOR: Cisco Inc.
DESC: PowerKEY CAS Gateway 03-05-09
PSTAMP: aurora20090305085805
INSTDATE: Mar 18 2009 15:56
STATUS: completely installed
FILES: 11 installed pathnames
3 executables
1986 blocks used (approx)
11 Type exit and press Enter to close the xterm window.
12 Continue with the next chapter to configure the PCG on the DNCS/ISDS.
12 Continue with the next chapter to configure the PCG on the DNCS/ISDS.