Cisco PowerKEY CableCARD Module 802 Installation Guide
Chapter 4 Configure the PCG on the DNCS or ISDS
26
78-4017672-01 Rev E
Configure the PCG on the ISDS
Complete the following steps to configure the PCG on the ISDS.
Note: If your system controller device is a DNCS, follow the instructions in the
previous section in this chapter.
previous section in this chapter.
1 Obtain the PCG MAC address from the label on the PCG. You will also have
recorded this PCG MAC address during step 4 of Installing the PCG Bootup
Files (on page 17).
Note: Optionally, you may type /sbin/ifconfig eth0 and press Enter; then record
the MAC Address for the entry associated with the HWaddr value for the
following:
Files (on page 17).
Note: Optionally, you may type /sbin/ifconfig eth0 and press Enter; then record
the MAC Address for the entry associated with the HWaddr value for the
following:
Primary PCG MAC Address: _________________________
Secondary PCG MAC Address: _________________________
2 From the Administrative Console, select the Network Element Provisioning tab.
Click PCG.