Cisco PowerKEY CableCARD Module 802 User Guide
About This Guide
vi
78-4011765-01 Rev C
Related Publications
You may find the following publications useful as resources when you implement
the procedures in this document. Check the copyright date on your resources to
assure that you have the most current version. The publish dates for the following
documents are valid as of this printing. However, some of these documents may
have since been revised:
Best Practices for Using Single-Stream PowerKEY CableCARD Modules (part number
4015091, published September 2006)
System Release 2.5 Release Notes (part number 749253, published October 2005)
System Release 3.5 Release Notes (part number 4001159, published October 2005)
System Release 4.0 Release Notes (part number 4001703, published February 2006)
Procedure to Enable DNCS to Support New mmi Screen for M-Card™ (part number
736123, expected publish date: late 2006)
The PowerKEY CableCARD Module Installation Instructions, Model PKM800 (part
number 745460, expected publish date: late 2006)
Explorer® Digital Home Communications Terminal Staging Guide (part number
734375, published September 2006)
Enabling Content Protection for Broadcast Programming (part number 4005893,
published September 2005)
Downloading New Client Application Platform Software Installation Instructions (part
number 4003052, published September 2005 [revision expected: late 2006])
Recommendations for Data Carousel Rate Management Technical Bulletin (part
number 716377, published June 2005)
PowerKEY CableCARD Module Installation Instructions, Model PKM600 (part
number 736104, published December 2003)
Document Version
This is the third release of this guide. In addition to minor text and graphic changes,
the following table provides the technical changes to this guide.
Description
See Topic
Added descriptions for configuring
M-Card modules
Throughout document
Added descriptions of PKM800 and
PKM802 M-Card modules
PowerKEY CableCARD and M-Card
Modules Supported (on page 2)