Cisco PowerKEY CableCARD Module 802 Installation Guide
Chapter 1 PKES Hardware Installation
4
4034718 Rev B
Rack Mounting
Installing the PKES in the Rack
Follow these steps to install the PKES in the rack using the angle support brackets.
CAUTION:
Avoid personal injury and damage to this product! Be sure to support the
server from underneath until it is securely positioned in the rack. Failure to
do so could result in the server falling to the floor. The server could be
damaged and you could be injured as a result.
Avoid personal injury and damage to this product! Be sure to support the
server from underneath until it is securely positioned in the rack. Failure to
do so could result in the server falling to the floor. The server could be
damaged and you could be injured as a result.
1 Make sure that the site requirements are met as outlined in the previous section.
2 Determine the approximate position in the equipment rack where you want the
2 Determine the approximate position in the equipment rack where you want the
bottom of the PKES to be located. Then, position the angle support brackets in
the rack. The cut-outs in the brackets must face toward the back of the rack as
shown in the following illustration.
the rack. The cut-outs in the brackets must face toward the back of the rack as
shown in the following illustration.