Cisco Model 8653-SU Addressable Transmitter Installation Guide
Installation Procedure
590212 Rev G
39
Using an Allen-head wrench, torque the two recessed Allen-head screws
from 30 in-lb to 40 in-lb (3.4 N-m to 4.5 N-m).
from 30 in-lb to 40 in-lb (3.4 N-m to 4.5 N-m).
5 Attach the coax cable to the MST-TA drop ports as desired. Make sure to tighten
to the manufacturer's recommended torque specification, usually 30 in-lb (40 N-
m).
Note: Provide strain relief for the coax cable drop per manufacturer's
recommendation.
m).
Note: Provide strain relief for the coax cable drop per manufacturer's
recommendation.
CAUTION:
Avoid damage to this product. Before installing any terminators, make sure
AC is not present on the drop ports.
Avoid damage to this product. Before installing any terminators, make sure
AC is not present on the drop ports.
6 Insert the twisted pair wire leads through the perforated holes and through the
gel. The ground wire must be connected to the GND terminal, and the hot wire
must be connected to the HOT terminal.
must be connected to the HOT terminal.