Cisco Cisco D9858 Advanced Receiver Transcoder Installation Guide

 

212 

78-4023074-01 Rev J 

From the user interface of the D9858, click Support > Service Actions > Service 
Actions. The Service Actions page is displayed. 

 

The S/W Version drop-down list allows you to select/load a different application 
version to your receiver. Click Select & Reboot to load the selected application 
version and reboot the receiver. 

Click Erase to remove the selected application version. You will be prompted to 
continue or not. Press OK to continue the deletion. 

Click Factory Reset to perform a reset of receiver settings back to the factory set 
(default) values. A warning message prompts you to confirm the operation. Click 
OK to continue or No to cancel the operation. 

Click Reboot Receiver to reboot the receiver. You will be prompted to verify the 
operation. Click Yes to reboot the receiver or No to cancel the operation. 

 

In the Download APP section, click Browse to select the new version of FPGA or the 
D9858 Advanced Receiver Transcoder’s software application. The Choose File dialog 
opens. Select the upgrade file and click Open. Click Download to download the 
selected upgrade file. File formats that can be downloaded include Application 
CDTs and FPGA CDTs. 

Note: For application downloads, once the download is complete, the D9858 
transcoder will reboot automatically. For FPGA downloads, you must click Reboot 
Receiver to manually reboot the D9858 transcoder and complete the download. This 
is to facilitate the typical case in which the user intends to flash the FPGA file (no 
auto reboot) followed by an APP download (auto reboot).