Cisco Cisco D9858 Advanced Receiver Transcoder Installation Guide

 

252 

OL-31087-01 

3  The Warning Setup area displays a list of the warning messages. For more 

information on warning messages, refer to D9858 Transcoder Alarm Messages 
(on page 280).  

4  Set Enable/Disable to Yes and the warning message will be reported. Set to No 

and the warning is disabled and the Relay and Trap settings are ignored. 
Note: Enable/Disable must be set to Yes for the Relay and Trap settings to be 
functional. 

5  If current warning is enabled, choose Yes from the Trap drop-down list and the 

SNMP trap message will be sent when the warning is set or cleared. 
Note: No is a read only value that indicates the setting is Yes, but is currently 
being suppressed because the warning is disabled (Enb is set to No). 

6  If current warning is enabled, choose Yes from the Relay drop-down list for the 

rear panel alarm relay to be triggered when the warning is set or cleared. 
Note: No is a read only value that indicates the setting is Yes, but is currently 
being suppressed because the warning is disabled (Enb is set to No). 

7  Click Apply.