Cisco Cisco Surge-Gap Passives Installation Guide

Page of 52
Chapter 2    Installing the Tap/Passive 
 
 
 
Installing the Tap/Passive on a Strand 
The strand-mounted configuration has the feeder cable entering one side of the unit 
and exiting the other side. The unit has one strand clamp with a strand clamp bolt 
and uses a standard cable strand for mounting. 
 
To Install the Tap/Passive on a Strand 
Follow these steps to install tap/passive on a strand. 
1.  Using a 3/8-in. wrench, loosen the strand clamp bolt. 
2.  Attach the tap/passive to the strand making sure that the strand enters the 
strand clamp. 
 
3.  Secure the strand clamp to the strand by tightening the strand clamp bolt with a 
3/8-in. wrench from 30 in-lb to 40 in-lb (3.4 Nm to 4.5 Nm). 
4.  Using a 3/16-in. hex-head driver or 3/16-in. straight blade screwdriver, loosen 
the two seizure screws inside the housing. 
 
14 
OL-31976-01