Cisco Cisco Surge-Gap Passives Installation Guide
Chapter 2 Installing the Tap/Passive
To Install the Tap/Passive in a Pedestal
Follow these steps to install tap/passive in a pedestal.
1. Using a 3/8-in. wrench, remove the strand bolt and strand clamp from the
1. Using a 3/8-in. wrench, remove the strand bolt and strand clamp from the
housing.
2. Mount the housing to the pedestal-mounting bracket using the strand bolt. Use
the strand clamp as a spacer, if necessary.
3. Using a 3/8-in. wrench, tighten the strand bolt from 30 in-lb to 40 in-lb (3.4 Nm
to 4.5 Nm).
4. Using a 3/16-in. hex-head driver or 3/16-in. straight blade screwdriver, loosen
the two seizure screws inside the housing.
18
OL-31976-01