Cisco Cisco Content Delivery System Manager Installation Guide

Page of 64
Installing the VDS-SM Analytics Indexer
The procedure that follows assumes that all VDS-SM VMs have been created and deployed. If this has
not been completed, make sure that it is done before you proceed.
Also, this procedure uses the similar installation and configuration procedure as the Core Services node.
Refer to the
Configuring the VDS Core Management Services Node
for screens and additional information
that are generic to all installation and configuration.
Note
To install the VDS-SM Analytics Indexer, perform the following steps:
Step 1
Using the VMware’s vSphere client, access the ESXi host where the OVF VMs are located.
Step 2
Right-click the Analytics Indexer VM, select Power Power On.
Step 3
When the VM is powered on, right-click the VM again and select Open Console. Allow the VM to complete starting
the boot procedure.
Step 4
When the boot process completes, select Sign in.
Step 5
Log in using the default credentials; User Name: admin and Password: password.
Step 6
If this is your initial login, the system prompts you to change the password.
Step 7
Change the password as desired. Click Change when finished. The Main Menu is displayed.
Step 8
Select Network Configuration. The default networking configuration is displayed.
Step 9
If the IP addressing is not obtained via DHCP, enter the Default Gateway, choose the Eth0 interface, and press Enter.
Step 10
Select a unique hostname for the Node. This hostname must be unique from all other analytics nodes.
Step 11
Set the DNS server setting to that of the Core Services node. Press Enter.
Step 12
Enable Eth0. If configuring static addressing, deselect the DHCP option and specify the IP address and netmask.
Step 13
Enter the IP Address and netmask. Select Save. The completed network configuration is displayed.
Step 14
Select Save.
Step 15
Select Restart to re-initialize the Eth0 interface and save the configuration.
The window may be blank for some time. Wait for some time, as this is a normal behavior.
Note
Step 16
Select OK. The Main Menu is displayed.
Step 17
Select Log out.
When the initial network configuration has been completed, the next step is to log into the UI and define the
network settings.
   Videoscape Distribution Suite Service Manager Software Installation Guide
40
OL-29474-01  
VDS-SM Installation and Configuration
Installing the VDS-SM Analytics Indexer