Cisco Cisco Content Delivery System Manager Installation Guide
• Select extended wms-90 from within the Log File Format.
e
Within the Splunk UF Export Settings, configure the following:
• Enable Export Enable and select the log types to export.
• Enter Analytics Forwarder node IP address as the export server or enter Port as 9998.
2
To configure the SR Log, log into CDSM and then navigate to Device > Select a SR and Edit > General
Settings > Notification and Tracking > Transaction Logging. Configure the SR Log configuration
using the steps a to d, as shown in Step 1.
Settings > Notification and Tracking > Transaction Logging. Configure the SR Log configuration
using the steps a to d, as shown in Step 1.
Configuring VDS-SM Redundancy
The configuration mentioned in this section is feasible only when the setup includes four Indexers and two
ESX servers. The configuration will vary depending on the setup.
ESX servers. The configuration will vary depending on the setup.
To configure VDS-SM Redundancy, perform the following steps:
Step 1
Install each ESX (and the nodes within) independently. The nodes are installed the same way as VDS-SM is installed.
Step 2
Log in to the Secondary Forwarder as bninet and disable the Splunk process to prevent duplicate Mobi-TV client log
report.
ssh bninet@bniforwarder
report.
ssh bninet@bniforwarder
sudo /etc/init.d/splunkforwarder stop
Step 3
Install each HW Indexer.
Videoscape Distribution Suite Service Manager Software Installation Guide
OL-28652-01
55
VDS-SM Installation and Configuration
Configuring VDS-SM Redundancy