Cisco Cisco Content Acquirer Application Installation Guide
21
Cisco Internet Streamer CDS 3.2 Software Installation Guide for non-CDEs
OL-29023-01
Installing the UCS C200, UCS C210, UCS C220 and UCS C240 Platforms
Step 2
You can also power cycle the server using the Web Interface by clicking Power Cycle Server.
Setup the Internet Streamer CDS Release 3.2 Software
Step 1
Keep the SSH connection open. If you are disconnected, use an SSH client to connect to the CIMC on
the UCS with admin as the username.
the UCS with admin as the username.
ssh -l admin 172.22.68.39
Step 2
You are prompted to enter the password, use the password you previously set.
Step 3
Enter the following command:
ucs-server# connect host
The following message appears:
CISCO Serial Over LAN:
Close Network Connection to Exit
Press the 'Enter' key
Step 4
When prompted, enter the username and password previously set.
The CDS-IS application launches and you see the following:
NO-HOSTNAME#
Step 5
Setup CDS-IS by executing the Setup utility:
NO-HOSTNAME# setup
Refer to the “
” section of the Cisco Internet Streamer CDS 3.2 Quick Start
Guide for information on using the Setup utility to configure the device mode and network settings.