Cisco Cisco Content Acquirer Application Installation Guide
Americas Headquarters:
© 2012 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Cisco Internet Streamer CDS 3.0-3.1 Software
Installation Guide for non-CDEs
Installation Guide for non-CDEs
Revised: October 2012 OL-27397-03
This document provides detailed instructions for installing the Internet Streamer CDS Release 3.0-3.1
software on UCS C200, UCS C210 and Dell R720xd platforms. These procedures are located in the
following sections:
software on UCS C200, UCS C210 and Dell R720xd platforms. These procedures are located in the
following sections:
Installing the UCS C200 and UCS C210 Platforms
Before you Begin
You need the following to install the Internet Streamer CDS Release 3.0-3.1 software on a UCS C200
and UCS C210 platform:
and UCS C210 platform:
•
VGA monitor
•
USB keyboard
•
Minimum of two IP configurations, each with an Ethernet cable attached to a switch—one to the
CIMC (UCS Management port) and the other to one of the 6 NICs.
CIMC (UCS Management port) and the other to one of the 6 NICs.
Install the Hardware
The first step to getting a UCS server up and running is to install the server in its physical location. UCS
servers running Internet Streamer CDS Release 3.0-3.1 software are typically rack-mounted servers, so
you are most-likely installing the server to a rack. See the “
servers running Internet Streamer CDS Release 3.0-3.1 software are typically rack-mounted servers, so
you are most-likely installing the server to a rack. See the “
” section in the Cisco
UCS C200 Installation and Service Guide or the “
” section of the Cisco UCS C210
Installation and Service Guide for the rack installation procedure for the respective servers.