Cisco Cisco Content Delivery Engine 220 Technical References
MegaRAID SAS Controller Replacement Procedure
OL-27138-01
All contents are Copyright © 2012 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement.
29
Figure 32: LSI Reboot prompt
10. If the information in Figure 31 is shown on the screen, the configuration is correctly
imported. The server will boot up properly, then.
11.
If the prompt to import the “Foreign configuration” was not seen, verify the configuration
by loading the WebBIOS when prompted by entering “<CNTL>-H”. Follow the same
procedure as mentioned after Figure 25 (Figure 25 through 30).
by loading the WebBIOS when prompted by entering “<CNTL>-H”. Follow the same
procedure as mentioned after Figure 25 (Figure 25 through 30).
Figure 33: MegaRAID controller card correct initialization and Firmware
Post-Upgrade Procedure for CDE-420 CGW only:
1. Check for LED status on the interface ports
2.
When the CGW starts it’s POST procedure, enter the system BIOS setup by pressing
<DELETE>
<DELETE>
within the first 10 seconds and while the “enter BIOS” option is displayed on