Cisco Cisco AnyRes Live 5300 Information Guide

Page of 3
 
 
Product End-of-Life Notice 
© 2016 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. 
Page 1 of 3 
End-of-Sale and End-of-Life Announcement for the 
Cisco AnyRes Live Generation 3 Single-Input SDI 
Card and Blade Software 
EOL11155 
Cisco announces the end-of-sale and end-of-life dates for the Cisco AnyRes Live 
Generation 3 Single-Input SDI Card and Blade Software. The last day to order the 
affected product(s) is March 10, 2017. Customers with active service contracts or 
active warranties will continue to receive support from the Cisco Technical Assistance 
Center (TAC) as shown in Table 1 of the EoL bulletin. Table 1 describes the end-of-
life milestones, definitions, and dates for the affected product(s). Table 2 lists the 
product part numbers affected by this announcement. For customers with active 
service contracts or active product warranties, support will be available for the shown 
dates as stated in the applicable service contracts or product warranty terms and 
conditions. 
Table 1. 
End-of-Life Milestones and Dates for the Cisco AnyRes Live Generation 3 Single-Input SDI Card and Blade 
Software 
Milestone 
Definition 
Date 
End-of-Life 
Announcement Date 
The date the document that announces the end-of-sale and end-of-life of a product is 
distributed to the general public. 
September 9, 2016 
End-of-Sale Date 
The last date to order the product through Cisco point-of-sale mechanisms. 
The product is no longer for sale after this date. 
March 10, 2017 
Last Ship Date: 
HW, App. SW 
The last-possible ship date that can be requested of Cisco and/or its contract 
manufacturers. Actual ship date is dependent on lead time. 
June 8, 2017 
End of SW Maintenance 
Releases Date: 
App. SW 
The last date that Cisco Engineering may release any final software maintenance 
releases or bug fixes. After this date, Cisco Engineering will no longer develop, repair, 
maintain, or test the product software. 
March 10, 2018 
End of Routine Failure 
Analysis Date: 
HW 
The last-possible date a routine failure analysis may be performed to determine the 
cause of hardware product failure or defect. 
March 10, 2018 
End of New Service 
Attachment Date: 
HW, App. SW 
For equipment and software that is not covered by a service-and-support contract, this 
is the last date to order a new service-and-support contract or add the equipment 
and/or software to an existing service-and-support contract. 
March 10, 2018 
End of Service Contract 
Renewal Date: 
HW 
The last date to extend or renew a service contract for the product. 
June 5, 2021 
End of Service Contract 
Renewal Date: 
App. SW 
The last date to extend or renew a service contract for the product. 
June 6, 2019