Cisco Cisco Digital Service Access Node (DSAN) 8210 Installation Guide
Administration Group
OL-30954-01
125
SNMP Manager Table
Use the SNMP Manager table to enable traps to be sent to the IP addresses of up to
three different receivers or targets. The index into the table represents one of three
rows, designated 0 through 2.
three different receivers or targets. The index into the table represents one of three
rows, designated 0 through 2.
Complete the following steps to receive traps.
1 Set saDsanSnmpMgrEnable to enable (2).
2 Set saDsanSnmpMgrIP (in xxx.xxx.xxx.xxx format) to the IP address of the
1 Set saDsanSnmpMgrEnable to enable (2).
2 Set saDsanSnmpMgrIP (in xxx.xxx.xxx.xxx format) to the IP address of the
remote entity to receive traps.
3 Set saDsanSnmpMgrTrapPort to a valid available port.
The objects used in each of these steps are described below along with other related
objects.
objects.
saDsanSnmpMgrCount
This object holds the number of SNMP Manager IP addresses that are allowed to be
set at one time. A GET on this object always returns the value 3.
set at one time. A GET on this object always returns the value 3.
Access: Read-only
Syntax: Integer
OID: 1.3.6.1.4.1.1429.1.10.2.1.2.7.1
saDsanSnmpMgrEntry
This object holds a unique value that indicates the row of the SNMP Manager table
in which the corresponding entry is stored. Its value ranges from 1 to 3 (the value of
admSnmpMgrCount).
in which the corresponding entry is stored. Its value ranges from 1 to 3 (the value of
admSnmpMgrCount).
Access: N/A
Syntax: Integer
OID: 1.3.6.1.4.1.1429.1.10.2.1.2.7.2.1
saDsanSnmpMgrIndex
This object holds a unique value for each SNMP Manager IP address entry. Its value
ranges from 1 to 3 (the value of admSnmpMgrCount).
ranges from 1 to 3 (the value of admSnmpMgrCount).
Access: N/A
Syntax: Integer
OID: 1.3.6.1.4.1.1429.1.10.2.1.2.7.2.1.1