Cisco Cisco Digital Service Access Node (DSAN) 8210 Installation Guide
Installing Accessories
OL-30954-01
51
The pads on the outputs of the five analog block converters (CH1-CH5 OUT)
are installed at the factory to equalize the converter output levels. Do not
change these pads under any circumstances.
are installed at the factory to equalize the converter output levels. Do not
change these pads under any circumstances.
3 Install other options or accessories as desired, or proceed to Removing and
Installing AC Shunts (on page 54).
To Install Equalizers
Note: For best results, follow this installation procedure exactly.
Complete the following steps to install the equalizers in the RF module:
1 Begin this procedure with the housing open. See To Open the Housing (on page
1 Begin this procedure with the housing open. See To Open the Housing (on page
2 Install the forward input equalizer specified by the design print in the forward
input equalizer slot. Or, install the correct inverse equalizer specified by the
design print for your system in the forward input equalizer slot.
For a list of available GainMaker accessory pad values and part numbers, see
Technical Information (on page 211).
Note: Be sure that all the pins on the forward input equalizer or inverse equalizer
bottom align with the pin holes in the equalizer slot, allowing the equalizer to
install flat against the amplifier module.
design print for your system in the forward input equalizer slot.
For a list of available GainMaker accessory pad values and part numbers, see
Technical Information (on page 211).
Note: Be sure that all the pins on the forward input equalizer or inverse equalizer
bottom align with the pin holes in the equalizer slot, allowing the equalizer to
install flat against the amplifier module.
3 Install other options or accessories as desired, or continue with To Install the RF
Module (on page 56).