Cisco Cisco Digital Service Access Node (DSAN) 8210 Installation Guide
Chapter 4 CLI Diagnostics
66
OL-30954-01
Using CLI Commands
This section describes the commands you can enter at the DSAN> prompt to learn
about the current state and configuration of the DSAN.
about the current state and configuration of the DSAN.
Basic Commands
The following commands are available for obtaining basic DSAN information.
diagnostics
Use the diagnostics (or simply diag) command to display diagnostic screens
containing information about the current status and configuration of the DSAN.
containing information about the current status and configuration of the DSAN.
You can enter diag by itself to go to page 1 of the diagnostic screens, shown below.
Or, you can enter diag followed by a valid page number to go directly to the
designated page of the diagnostic screens.
designated page of the diagnostic screens.
The main diag pages are numbered 1-14. Some diag pages also have subpages.
Entering diag followed by a valid subpage number (e.g., 9.1) takes you to the
designated subpage.
Entering diag followed by a valid subpage number (e.g., 9.1) takes you to the
designated subpage.
Notes:
All diag pages have a >>> prompt at the bottom that lets you navigate directly to
any other diag page by entering the desired page number. This prompt also
recognizes the navigation commands p (previous), n (next), and s (subpage),
when appropriate.
any other diag page by entering the desired page number. This prompt also
recognizes the navigation commands p (previous), n (next), and s (subpage),
when appropriate.