Cisco GainMaker Optoelectronic Node 1GHz with 42 54 MHz Split Installation Guide
Installing and Removing the Transponder Module (Optional)
Installing and Removing the Transponder Module
(Optional)
To Install the Transponder Module
Follow the same approach to install the HMS Transponder and the DOCSIS
Transponder. Complete the following steps to install the status monitor module.
1 Open the node housing. Refer to
1 Open the node housing. Refer to
To Open the Node Housing (on page 15).
2 Align the transponder module connectors with the connectors on the interface
board. Use the tabs on the bottom of the transponder as a guide to position the
transponder correctly onto the interface board.
3 Secure the status monitor transponder by pushing down on the module until it
clicks into place.
4 Tighten the two module retaining screws on the transponder to 18-in-lb to 20
in-lb (2.0) Nm to 2.3 Nm).
Result:
Result:
If the GainMaker Node is active, the green "Heart Beat" LED flickers to
indicate the unit is operating.
If data packages are detected (e.g., to another transponder) the "Receive" LED
flickers.
5 Close the node housing. Refer to
To Close the Node Housing (on page 15).
6 For complete instruction on installing the DOCSIS Transponder, refer to the
Cisco DOCSIS®/EuroDOCSIS™ Transponder for GainMaker Node Installation
and Operation Guide, part number 4042915.
7 Refer to the section Configuring the Reverse Path of this guide for DOCSIS
Transponder operation.
OL-29644-03
43