Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split Installation Guide

 

If this equipment plugs into an outlet, the outlet must be near this equipment, 

and must be easily accessible. 

 

Connect this equipment only to the power sources that are identified on the 

equipment-rating label, which is normally located close to the power inlet 

connector(s). 

 

This equipment may have two power sources. Be sure to disconnect all power 

sources before working on this equipment. 

 

If this equipment does not have a main power switch, the power cord connector 

serves as the disconnect device. 

 

Always pull on the plug or the connector to disconnect a cable. Never pull on the 

cable itself. 

 

Refer to this equipment’s specific installation instructions in this manual or in 

companion manuals in this series for connection to network ferro-resonant AC 

power sources. 

 

AC power shunts may be provided with this equipment. 
Important:  The power shunts (where provided) must be removed before installing 

modules into a powered housing.    With the shunts removed, power surge to the 

components and RF-connectors is reduced. 

 

CAUTION: 
RF connectors and housing seizure assemblies can be damaged if 

removing modules from the housing. 

 

This section provides instructions for verifying that the equipment is properly 

grounded. 

Safety Plugs (USA Only) 
This equipment may be equipped with either a 3-terminal (grounding-type) safety 

plug or a 2-terminal (polarized) safety plug. The wide blade or the third terminal is 

provided for safety. Do not defeat the safety purpose of the grounding-type or 

polarized safety plug. 
To properly ground this equipment, follow these safety guidelines: 

 

Grounding-Type Plug - For a 3-terminal plug (one terminal on this plug is a 

protective grounding pin), insert the plug into a grounded mains, 3-terminal 

 

OL-29644-03 

ix