Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split Installation Guide
Digital Reverse Transmitter Module Installation
Complete the following steps to install the bdr transmitter module.
1 See
1 See
To Remove or Reinstall the Optical Transmitter for instructions on
removing and installing the module in the housing.
2 Remove any existing transmitter modules from the positions in which you want
to install the bdr transmitter module.
3 Install the bdr transmitter module in the housing lid in transmitter positions
XMTR 1/XMTR 2.
4 Configure the node reverse path for Segmented Reverse Path operation as
described in Configuring the Reverse Path. Note that this configuration requires
a Segmented RCM, part number 4015143, and a Segmented OIB plug-in, part
number 4015162.
WARNING:
Laser transmitters when disconnected from their optical fiber path
emit invisible laser radiation, which is harmful to the human eye. If
viewed at close range, the radiation may be of sufficient power to cause
instantaneous damage to the retina of the eye. Only trained service
personnel using proper safety precautions and equipment such as
protective eyewear should disconnect and service the laser transmitter
equipment.
OL-29644-03
103