Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split Installation Guide
Chapter 2 Installation and Configuration
Connecting the Fiber Optic Service Cable to the
Node
Warning: Radiation
WARNING:
Avoid personal injury! Use of controls, adjustments, or procedures other
than those specified herein may result in hazardous radiation exposure.
Avoid personal injury! The laser light source on this product emits
invisible laser radiation. Avoid direct exposure to the laser light source.
Do not apply power to this product if the fiber is unmated or unterminated.
Do not stare into an unmated fiber or at any mirror-like surface that could reflect
light that is emitted from an unterminated fiber.
Do not view an activated fiber with optical instruments.
Fiber Cable Handling
With repeated use, optical connectors can become dirty or scratched. This can
seriously degrade system performance. It is critical that connectors be maintained in
good condition. Do not disconnect or connect any connectors unless absolutely
necessary. Always clean both halves of each connector with a alcohol solution (99%
recommended) and lint-free wipes when preparing to join the two halves. Use
compressed air to clean the adapter.
Note: A ferrule cleaner, part number 468517, may be ordered for use with SC and FC
Note: A ferrule cleaner, part number 468517, may be ordered for use with SC and FC
style connectors.
Fiber Connectors and Fiber Optic Service Cable
The following illustration shows the fiber connectors available with the node when
using fiber optic service cables.
Note: To order additional service cables, refer to the following chart.
18
OL-29644-03