Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split Installation Guide
Balancing the Forward Path
Balancing the Forward Path
To complete the balancing procedure, you will perform the following tasks:
Determine the output tilt.
Set the output tilt.
Set the output level.
This section provides instructions for performing each of these tasks.
Note: Before you begin, make sure that you have configured the amplifier module
Note: Before you begin, make sure that you have configured the amplifier module
according to the specifications in the design print, and that the amplifier has warmed
up for approximately one hour.
To Determine the Output Tilt
Complete the following steps to determine the output tilt of the amplifier.
1 Connect the test point adapter to the Port 1 forward output test point.
1 Connect the test point adapter to the Port 1 forward output test point.
2 Consult the design print to find the proper output tilt.
3 Measure the output signal levels at the frequencies you used in To Verify the
3 Measure the output signal levels at the frequencies you used in To Verify the
Input Signal Level.
4 To determine the actual output tilt, calculate the difference (in dB) between the
levels of the lowest and highest specified frequencies.
5 Proceed to the next section, To Set the Output Tilt.
To Set the Output Tilt
Equalizers (EQs) are available in 1.5 dB increments. A 1.5 dB change in value
changes the difference between low and high frequencies by approximately 1 dB.
Increasing the FWD I/S equalizer value reduces the level at lower frequencies,
OL-29644-03
49