Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split Installation Guide
Forward Path Balancing for AGC Stations Using Thermal Setup Mode
6 Move switch S1 back and forth between position 1 and position 3.
Important: Let the amplifier module settle before reading signal levels.
The signal level should not vary when you switch between positions 1 and 3. If
The signal level should not vary when you switch between positions 1 and 3. If
the signal level does vary, repeat steps 4 through 6 as needed until the signal
level does not vary between switch positions 1 and 3.
7 Set switch S1 to position 3 for AGC operation mode.
8 Proceed to
8 Proceed to
Balancing the Reverse Path (on page 73).
OL-30035-03
67