Cisco Model D-PCG1000 PowerKEY CAS Gateway
Configure the ISDP for EPG Search
4038960 Rev A
101
Example: Add SAM Service Window
5 Click Save.
Verify that EPG Search Works
Before you can verify that EPG search works as expected, the IPG collector must be
run. Normally, this occurs overnight, but you can check the EPG search functionality
immediately by completing the following steps:
1 Run the IPG collector.
2 Authorize the set-top for the package.
3 Reboot the set-top box.
4 Press Guide and then select Search to see if EPG search works as expected. Then
1 Run the IPG collector.
2 Authorize the set-top for the package.
3 Reboot the set-top box.
4 Press Guide and then select Search to see if EPG search works as expected. Then
verify that EPG search is available from the main TV menu.
Setting Persistent Routes (Optional)
Depending on your configuration, you may need to change the routes in your
routing table and make them persistent. Follow these steps if you need to set
persistent routes.
1 On the ISDS as root user, type cd sysconfig/ and press Enter.
2 Type cd network-scripts/ and press Enter.
3 Type vi route-eth0 and press Enter to edit the route-eth0 file.
1 On the ISDS as root user, type cd sysconfig/ and press Enter.
2 Type cd network-scripts/ and press Enter.
3 Type vi route-eth0 and press Enter to edit the route-eth0 file.
Example:
GATEWAY0=10.90.160.1
NETMASK0=255.0.0.0
ADDRESS0=64.0.0.0
GATEWAY1=10.90.160.1
NETMASK1=255.255.255.0