Cisco Cisco Digital Service Access Node (DSAN) 8200 Installation Guide

 

OL-29943-01 

41 

 

The following procedures detail how to install the DSAN housing: 



 

On a wall 



 

In a 19-inch equipment rack 



 

On a strand 



 

In a pedestal or cabinet 

 

Complete the following steps to install the DSAN housing on a wall or in a 19-inch 
equipment rack. 
1 

Carefully select and prepare the area to receive the DSAN unit. 



 

Consider the weight of the DSAN unit itself, the mounting bracket, and all 
attached cabling and accessories. 



 

Consider any possible accidental impact from passing foot traffic or moving 
objects. Avoid mounting the unit in high traffic areas. 



 

Consider any additional stress that may be placed on the mounting surface 
and hardware by accidental snagging of attached cabling. 



 

When mounting the unit on a wall, choose a location that allows for 
mounting into studs. Pre-drill pilot holes into the studs for four 5/16 x 2-inch 
(minimum length) lag bolts. Use the mounting bracket, part number 4028925, 
as a guide. 



 

When mounting the unit in a rack, note that the height of the mounting 
bracket occupies 14 in. (35.6 cm) or 8 rack units. 

2  Remove the two self-tapping bolts from the strand clamps. Set the bolts and 

strand clamps aside. 

3  Place a lock washer and a flat washer on each self-tapping strand clamp bolt, 

arranged so that the lock washer is directly under the head of each bolt. 

Pass the self-tapping bolts with washers through the mounting bracket, part 
number 4028925, and into the back of the housing as shown in the following 
illustration. Torque the self-tapping bolts from 8 to 10 ft-lb (10.8 to 13.6 Nm).