Cisco Headend System Release 2.7
Set Up CF Sessions for the Additional BFS QAM
4017541 Rev B
25
Finding the BFS BIG Program Numbers
1 On the DNCS Administrative Console, click the DNCS tab, and then click the
1 On the DNCS Administrative Console, click the DNCS tab, and then click the
Network Element Provisioning tab.
2 Click BIG. The BIG List window opens.
3 Select the headend corresponding to your primary BFS QAM.
4 On the File menu, click Open. The Set Up BIG window opens.
5 Click PAT Configuration. The BIG PAT window opens.
3 Select the headend corresponding to your primary BFS QAM.
4 On the File menu, click Open. The Set Up BIG window opens.
5 Click PAT Configuration. The BIG PAT window opens.
6 From the BIG PAT table, note the program numbers for sessions 2 through 22 (or
24 if you are using SDV) and the OSM session on the Worksheet at the end of this
chapter.
chapter.
7 Click Close in the BIG PAT window.
8 Click Cancel in the Setup BIG window.
9 Click the File menu and then click Close. The BIG List window closes.
10 Go to Setting Up Source Definitions and CF Sessions (on page 27) to set up the
8 Click Cancel in the Setup BIG window.
9 Click the File menu and then click Close. The BIG List window closes.
10 Go to Setting Up Source Definitions and CF Sessions (on page 27) to set up the
source definition and build the CF sessions for the BFS QAMs.