Cisco Model D-PCG1000 PowerKEY CAS Gateway Data Sheet

 

 

 

The Digital Network Control System (DNCS) V880 platform features hot-swappable 
disks, power supplies, and cooling fan trays. All PCI slots comply with PCI Local Bus 
Specification Revision 2.1 and support PCI hot-plug operations. This high level of 
reliability is further enhanced by the addition of redundant FC-AL disk controllers.  

An easy-to-use front panel display provides general system status, alerts you to system 
problems, and helps you determine the location of system faults.

 

 

Two hardware configurations of the DNCS V880 platform are available to match your 
broadband requirements: 

•  DNCS V880-2, featuring two, 900-MHz CPUs; 4-GB RAM total; and a total of six, 

73-GB disks   

•  DNCS V880-4, featuring four, 900-MHz CPUs; 8-GB RAM total; and a total of twelve, 

73-GB disks  

The DNCS V880 platform requires System Release (SR) 2.1.1 or SR 3.0.1 or later.  In 
addition, the DNCS V880 platform requires the DBDS IP traffic to be routed separately 
from the ATM traffic.  This setup may require some existing sites to reconfigure their 
DBDS/DNCS network to route out-of-band IP traffic through 10/100BaseT Ethernet or 
Gigabit Ethernet.  

Input 

 

Nominal Frequencies 

50 Hz or 60 Hz nominal 

 

Nominal Voltage Range 

Autoranging 100–240 VAC 

 

Maximum Current AC RMS 

15.0 A @ 100 VAC (each power cord) 

 

AC Operating Range 

90–264 Vrms, 47–63 Hz 

Output 

 

+3.3 VDC 

3 to 72 A 

 

+5 VDC 

3 to 56 A 

 

+12 VDC 

1 to 35 A 

 

+48 VDC 

0 to 31.2 A 

Maximum DC Power Output 

2240 Watts 

Maximum AC Power Consumption 

3000 Watts 

Maximum Heat Dissipation 

10,308 BTU/hr 

Volt-Ampere Rating 

1515 VA with 1120 Watt load (PF=0.99)