Cisco Headend System Release 2.7
Appendix B
Remove the Services Portal From Your System
154
78-745238-01 Rev D
Remove the Inband Carousel From the PAT Table
Process Overview
To remove the inband carousel from the BIG PAT table, you must complete the
following procedures.
1 Stop the OSM process on the DNCS.
2 Delete the Services Portal and OSM session from the PAT table.
3 Tear down the BFS sessions.
1 Stop the OSM process on the DNCS.
2 Delete the Services Portal and OSM session from the PAT table.
3 Tear down the BFS sessions.
Stopping the OSM Process
1 If the DNCS Control window is not already open, click the Control button in the
DNCS area of the DNCS Administrative Console Status window.
Result: The DNCS Control window opens.
2 From the list of processes, click osm.
3 Click Process > Stop Process. A confirmation message appears.
4 Click Yes to stop the OSM process. This causes the indicator next to OSM to turn
3 Click Process > Stop Process. A confirmation message appears.
4 Click Yes to stop the OSM process. This causes the indicator next to OSM to turn
red.
5 Are you using a BIG or ASI?
If you are using a BIG, go to Deleting Services Portal and OSM From the
BIG PAT Table.
If you are using ASI, go to Deleting Services Portal and OSM From the ASI
PAT Table (on page 159).
Deleting Services Portal and OSM From the BIG PAT Table
Important:
Before you begin this procedure, make sure you know the source ID for the
inband Services Portal source. You recorded this ID in step 3 of Deleting the
Inband and Out-of-Band BFS Carousels (on page 150).
If you use ASI in your system, follow the procedure in Deleting Services Portal
and OSM From the ASI PAT Table (on page 159).
1 On the DNCS Administrative Console, click the DNCS tab if it is not already
active.
2 Click the Element Provisioning tab.