Cisco Model D-PCG1000 PowerKEY CAS Gateway User Guide
4012159 Rev B
Setting Up the Interactive Program Guide
5-31
Adjust How DHCTs Use IPG Memory
Introduction
After you configure the IPG Memory Usage settings on the DNCS, use the DHCT
Configure utility to send these settings to DHCTs. Otherwise, DHCTs are unable to
fine-tune how they use IPG memory.
Important! Be aware that the DHCT Configure utility sends not only the IPG
Important! Be aware that the DHCT Configure utility sends not only the IPG
Memory Usage settings to DHCTs, but also sends any other settings configured in
the DHCT Configuration windows. For a description of all the settings that can be
configured from DHCT Configuration windows, refer to Enhancing Your Subscribers'
Experience: SARA Configurable Options.
Sending IPG Memory Usage Settings to DHCTs
You can use either of the following methods to send settings to DHCTs:
•
•
Global – Sends the settings to all DHCTs in your network. For assistance using
this method, refer to Send a Global Configuration to All Set-Tops in Your
Network in Enhancing Your Subscribers' Experience: SARA Configurable Options.
•
Hub-Specific – Sends the settings to DHCTs in a specific hub. This method allows
you to test the settings on DHCTs in the headend before applying the settings to
all DHCTs in your network. For assistance using this method, refer to Build and
Send a Configuration to All Set-Tops in a Single Hub in Enhancing Your
Subscribers' Experience: SARA Configurable Options.