Cisco Model D-PCG1000 PowerKEY CAS Gateway User Guide
3-2
Setting Up Language Support
4009747 Rev B
Set Up Supported Languages
Introduction
To set up other languages for your IPG, use the Languages user interface located on
the Server Applications tab of the DNCS Administrative Console. For each language
that you set up, there must be an IPG server and an IPG collector to support the
language. The DNCS allows one IPG server per active language. You must complete
the following tasks when setting up supported languages.
1. Verify and select the appropriate languages your system supports.
2. Create a server and a collector for each language you select.
For procedures to create a server and a collector, see Set Up the IPG in Chapter 5 of
1. Verify and select the appropriate languages your system supports.
2. Create a server and a collector for each language you select.
For procedures to create a server and a collector, see Set Up the IPG in Chapter 5 of
this guide.
Verifying and Selecting the Appropriate Languages
Perform the following steps to verify that the DNCS recognizes the languages your
DBDS supports.
1.
On the DNCS Administrative Console, select the Server Applications tab.
2.
Click Languages.
Result: The Supported Languages
Result: The Supported Languages
window opens.
Notes:
•
Notes:
•
Standard DHCT code supports
English, French, and Spanish.
•
Special DHCT code is required to
support Japanese.
3.
If the languages your DBDS supports are not selected, select them.
Note: In the example in step 2, only English is selected. However, if your
Note: In the example in step 2, only English is selected. However, if your
system requires French or Spanish select those options as well, and then click
Save.
4.
Click Close to exit the Supported Languages window.