Cisco Cisco Digital Service Access Node (DSAN) 8200 Troubleshooting Guide
Chapter 3 CMTS Registration
28
4032301 Rev A
Confirming CMTS Registration
Given proper headend support and DSAN hardware setup, the DSAN should
configure automatically during the bootup period that immediately follows power-
up.
configure automatically during the bootup period that immediately follows power-
up.
Important: The DSAN bootup process takes several minutes to complete. There is no
video output from the unit until the bootup process is complete.
video output from the unit until the bootup process is complete.
To confirm proper CMTS registration during bootup, first complete the following
steps.
1 Before applying power to the DSAN, open the unit and connect a PC laptop to its
steps.
1 Before applying power to the DSAN, open the unit and connect a PC laptop to its
diagnostic port. See the CLI Diagnostics chapter of the Cisco DSAN System
Installation and Operation Guide, part number 4032302 for assistance as needed.
Installation and Operation Guide, part number 4032302 for assistance as needed.
2 Apply power to the DSAN and allow 5 minutes for the unit to boot up and
complete its cable modem registration process. The dsan login: prompt appears
on the PC laptop screen.
on the PC laptop screen.
3 Log in to the DSAN using the default user ID dsan and password dsan1234. Both
user ID and password are case-sensitive. The DSAN> prompt appears.
Then use the following descriptions of the registration and connection sequence to
confirm successful CMTS registration.
confirm successful CMTS registration.