Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Installation Guide
Chapter 3 Installation
84
OL-29643-02
WARNING:
Laser light hazard. The laser light source on this product emits
invisible laser radiation. Avoid direct exposure. Never look into the
end of an optical fiber or connector. Failure to observe this warning can
result in eye damage or blindness.
end of an optical fiber or connector. Failure to observe this warning can
result in eye damage or blindness.
Do not apply power to this product if the fiber is unmated or unterminated.
Do not stare into an unmated fiber or at any mirror-like surface that could reflect
light that is emitted from an unterminated fiber.
light that is emitted from an unterminated fiber.
Do not view an activated fiber with optical instruments.
1 The first step depends on whether the fiber optic cable is factory installed or not.
IF... THEN...
fiber optic cable is
factory installed
factory installed
splice fiber pigtail of optical fiber input cable to your splice
enclosure and continue to RF Cable Installation.
enclosure and continue to RF Cable Installation.
fiber optic cable is
not installed
not installed
go to step 2.
2 Select the right or left fiber connection port for use and remove its sealing plug.
3 Push in the two release tabs at the top of the fiber tray and swivel the top of the
fiber tray up and back to allow a clear view of the fiber routing channel below.