Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Installation Guide
Fiber Optic Cable Installation
OL-29643-02
87
receiver or transmitter module each fiber will connect.
10 Pivot the fiber tray back down and snap it into place on top of the power supply
with its locking tabs.
11 Open the fiber tray cover and carefully wind the fibers around the spool in a
counterclockwise direction. Be sure to leave enough fiber so that each connector
can reach its intended module. Note that different diameter spool paths are
provided to properly adjust the fiber length.
can reach its intended module. Note that different diameter spool paths are
provided to properly adjust the fiber length.
12 Route each fiber to its intended module through the fiber track as shown.
13 Before connection, carefully clean the optical connectors on both fiber and
13 Before connection, carefully clean the optical connectors on both fiber and
module according to the procedures in Care and Cleaning of Optical Connectors
(on page 148).
(on page 148).
14 Open the receiver or transmitter module fiber connector cover. Carefully slide
the fiber connector into the module connector until it clicks.
15 Repeat steps 12 and 13 for each receiver and transmitter module.
16 Splice fiber pigtail of optical fiber input cable to your splice enclosure.
17 Continue to RF Cable Installation (on page 88).
16 Splice fiber pigtail of optical fiber input cable to your splice enclosure.
17 Continue to RF Cable Installation (on page 88).