Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Chapter 3 Operating the DAVIC QPSK Demodulator
22
78-545617-01 Rev F
Reading the Default Status Screen
Introduction
This section describes the Default Status screen. The QPSK demodulator displays the
Default Status screen after one of the following events occurs:
The power-on self-test sequence is complete.
The ENTER key is pressed.
A minute elapses after a key has been pressed (except when in the TEST menu).
Default Status Screen Information
The following is an example of the Default Status screen.
The following table describes the information displayed on the preceding example of
a Default Status screen.
Display
Function
21.000 MHz
Configured input frequency
LO [][][][][] HI
Configured input range
Unit OK
Summary status (if an alarm condition occurs, the alarm condition
messages will show here instead of Unit OK)
Node 1
User-defined node identifier of assigned neighborhood