Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Add a Service Group
4014102 Rev C
59
Note: The CCM Process helps keep Cisco informed of network changes as you
make them. This allows us to help troubleshoot your system more effectively
and efficiently should the need arise. If you are not familiar with the CCM
process, contact Cisco Services immediately for further assistance.
make them. This allows us to help troubleshoot your system more effectively
and efficiently should the need arise. If you are not familiar with the CCM
process, contact Cisco Services immediately for further assistance.
13 Do you need to add another service group?
If yes, repeat steps 3 through 12.
If no, click Exit to close the Service Group Data window and return to the
DNCS Administrative Console.
DNCS Administrative Console.
14 Are you setting up your network for the first time?
If yes, go to step 15.
If no, continue making any other changes that you need to make to your
network. When finished, send a copy of your updated network map to Cisco
as specified in the CCM process. Then go to step 17.
network. When finished, send a copy of your updated network map to Cisco
as specified in the CCM process. Then go to step 17.
15 Are you using SONET interfaces in your network?
If yes, go to Setting Up SONET topic in the DNCS help. Then return to this
procedure and continue with step 16.
procedure and continue with step 16.
If no, go to step 16.
16 Does your network comply with OpenCable standards?
If yes, go to Setting up OpenCable Compliance topic in the DNCS help. Then
return to this procedure and continue with step
return to this procedure and continue with step
If no, continue making any other changes that you need to make to your
network. When finished, send a copy of your updated network map to Cisco
as specified in the CCM process. Then go to step 17.
network. When finished, send a copy of your updated network map to Cisco
as specified in the CCM process. Then go to step 17.
17 When provisioning is complete, power on the GQAM.
18 After the modulator boots, click Element Provisioning on the DNCS
18 After the modulator boots, click Element Provisioning on the DNCS
Administrative Console.
19 Click QAM and select the modulator you just added.
20 From the File menu, click Open. The Set Up GQAM window opens.
21 From the Basic Parameters area, verify that the Administrative State for the new
20 From the File menu, click Open. The Set Up GQAM window opens.
21 From the Basic Parameters area, verify that the Administrative State for the new
GQAM is set to Online.