Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Chapter 4 Operating the Modulator
74
4014102 Rev C
Mute the RF Output of a Selected CH Carrier
Introduction
This section contains instructions for enabling the RF mute option. During
installation, for example, use this procedure to mute the RF output before you
connect the RF OUT ports to the distribution plant.
installation, for example, use this procedure to mute the RF output before you
connect the RF OUT ports to the distribution plant.
Enabling or Disabling a Muting Option
Important! The RF output state established from the front panel of the GQAM is not
recorded by the DNCS. At the next modulator restart, the RF output state reverts to
the value stored in the DNCS.
1 On a GQAM that has power connected and has finished booting, press the
recorded by the DNCS. At the next modulator restart, the RF output state reverts to
the value stored in the DNCS.
1 On a GQAM that has power connected and has finished booting, press the
LEVEL key twice. The Output Mute screen appears.
2 Press RF SEL to choose a channel.
3 Press the Up and Down Arrow keys to toggle the selected RF Mute between
3 Press the Up and Down Arrow keys to toggle the selected RF Mute between
Off and Mute.
Note: When the selected output is set to Mute, the modulator displays RF Mute
on the default screen.
Note: When the selected output is set to Mute, the modulator displays RF Mute
on the default screen.
4 Press ENTER. The system saves the RF output muting changes to NVRAM and
the default screen appears.
Note: RF Mute appears on the default status screen for the selected channel.
Note: RF Mute appears on the default status screen for the selected channel.