Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Provision an IF GoQAM on the DNCS
4004834 Rev D
71
Provision an IF GoQAM on the DNCS
In order for the IF GoQAM to operate properly as a network element within the
DBDS, you must provision the IF GoQAM on the DNCS. This section provides
procedures for provisioning an IF GoQAM on the DNCS.
Before You Begin
Before you begin to provision the GoQAM on the DNCS, you need the following
information:
IP address of the GoQAM
Physical (MAC) address of the GoQAM
Name you need to assign to the GoQAM
Headend to which you need to assign the GoQAM
RF frequencies for each output port
Modulation type this GoQAM will use
Transport Stream IDs for each port of the GoQAM
Interleaver Depth for this GoQAM
Provisioning an IF GoQAM on the DNCS
Follow these steps to provision a new IF GoQAM or to adjust the settings for an
existing IF GoQAM on the DNCS.
1 Verify that you have provisioned the IF GoQAM in accordance with your
1 Verify that you have provisioned the IF GoQAM in accordance with your
network wiring diagram and the input/output specifications for the IF GoQAM
(Appendix A) and other network devices.
Note: Refer to the Digital Network Control System Online Help for your system
Note: Refer to the Digital Network Control System Online Help for your system
release for more information about provisioning network elements.
2 From the DNCS Administrative Console, select one of the following tabs:
For SR 2.7/3.7/4.2 and later, click the Network Element Provisioning tab.
For SR 2.5/3.5/4.0 and earlier, click the Element Provisioning tab.