Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
![Cisco](https://files.manualsbrain.com/attachments/7380d0050044647c30f5c24bbbf5d0c0b6d9bb84/common/fit/150/50/faa183d287233c52228cfea3dbc2a127fe780f60564fcb0955d9c3d1cd23/brand_logo.png)
Chapter 5 Operating the RF Modulator
82
4004834 Rev D
Changing the Boot Mode
1 Connect a diagnostic PC to the CRAFT PORT on the back panel of the GoQAM.
2 Power on the diagnostic PC and activate a Procomm or Hyperterminal window
2 Power on the diagnostic PC and activate a Procomm or Hyperterminal window
using the following modem connection settings:
9600 baud
1 stop bit
No parity
8 data bits
No flow control
3 Power on the GoQAM; then, during the boot sequence, watch for the following
message on the PC monitor screen:
Type any key within 2 seconds to get shell prompt
Note: See the
Note: See the
Connect Power Sources (on page 27) section for more details about
powering on the GoQAM.
4 Press any key on the PC to display the boot prompt. The following boot prompt
appears: boot>
Note: If you do not press a key in time to get the boot prompt, do one of the
Note: If you do not press a key in time to get the boot prompt, do one of the
following:
Cycle power to the GoQAM, and repeat this step. See Resetting the
Modulator for more details.
At the GoQAM> prompt, type boot; then, after the Type any key message
appears, press any key to display the boot prompt.
5 At the boot prompt, type setbootmode and press Enter. The current boot mode
setting appears.
6 Type one of the following numbers to select the boot mode:
0 - Skip BootP
1 - Attempt BootP One Time
2 - Bootp Until Successful
Result: The system saves the new boot mode to nonvolatile memory (NVRAM)
with the new setting.
7 Type exit and press Enter. The GoQAM reboots using the new boot mode.
8 Disconnect the diagnostic PC.
8 Disconnect the diagnostic PC.