Cisco Model GS7000 4-Port Node 1 GHz with 65 86 Split Installation Guide

 

 

125 

 

Press the Auto Set-Up button on the LCM to initiate module discovery.   
The Auto-Setup process typically takes up to 30 seconds. 
Note: Node data monitoring is only available for GS7000 Nodes with a 
transponder-less EDR LCM installed. The PC-based GS7000 Hub ViewPort software 
is not available for GS7000 Node. 
 

 

Refer to the Cisco Prisma II EDR Receiver Installation Guide, part number 4044294, 
for detailed information on installing the EDR receiver module on the Prisma II.   

To Install the OPM Module on the Receiver Module 

The following diagram shows the OPM module installed on the receiver module of 
the Prisma II. 

 

To Configure the Receiver Mode 

The receiver mode can be configured in the Web UI interface though connection 
with the Prisma II platform.   

For complete configuration steps and setup precautions, refer to the Cisco Prisma II 
EDR Receiver Installation Guide, part number OL-29646, and the Cisco Prisma II 
Platform Configuration Guide, after system release 2.05.30, part number OL-27998.