Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Installation Guide
Chapter 1 General Information
6
Node Inputs/Outputs Diagram
The following diagram shows the system-level inputs and outputs of the 1.2 GHz
SHO GS7000 Node.
SHO GS7000 Node.
Note: Port 3 and 6 are only for power.
The AC can be applied through any housing base port and routed, if required,
to the other ports.
to the other ports.
The DC power supply modules can be fed by any housing base port (1
through 6).
through 6).
Modules Functional Descriptions
This table briefly describes each module. The 1.2 GHz SHO GS7000 Node may not
contain all these modules. See Theory of Operation (on page 11) for detailed
descriptions of the modules.
contain all these modules. See Theory of Operation (on page 11) for detailed
descriptions of the modules.
Module
Description
RF Amplifier
The RF Amplifier Module includes:
four forward RF output ports
four reverse inputs.
forward and reverse bandwidths that are established by diplexer
and reverse low pass filter assembly selection.
and reverse low pass filter assembly selection.
Optical Receiver
This module converts an optical signal from the headend into a
forward path RF signal. An SC/APC fiber connector is standard.
Optical power, test points, and status LEDs are provided.
forward path RF signal. An SC/APC fiber connector is standard.
Optical power, test points, and status LEDs are provided.