Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Installation Guide
Chapter 5 Maintenance
76
4 Reattach the fiber connector to the module cover and close the cover.
Diplexers, Equalizer, and Trim modules
The diplexer modules, equalizers, and High Pass Filter/Trim modules plug into the
RF amplifier assembly through cut-outs in its cover.
RF amplifier assembly through cut-outs in its cover.
To remove these modules, pull up carefully on their integrated handles until they
separate from the RF amplifier assembly.
separate from the RF amplifier assembly.
RF Amplifier Assembly Replacement Procedure
Follow this procedure to remove and replace the RF amplifier assembly.
1 Open the housing. See Opening and Closing the Housing (on page 68).
2 Remove the AC power shunts and make a note of their location for reinstallation
1 Open the housing. See Opening and Closing the Housing (on page 68).
2 Remove the AC power shunts and make a note of their location for reinstallation
in the replacement RF amplifier assembly.
CAUTION:
Damage to the node may result if AC power shunts are not removed before
replacing the RF amplifier assembly.
Damage to the node may result if AC power shunts are not removed before
replacing the RF amplifier assembly.
3 Loosen the seven shoulder screws securing the RF amplifier assembly to the
housing.
Note: The screw locations are identified by number, 1 through 7.
Note: The screw locations are identified by number, 1 through 7.
4 Insert a flat-blade screwdriver into the small holes in the metal handles on each
side of the RF amplifier assembly and pry up carefully to disconnect the RF