Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Installation Guide

 

4022871 Rev C 

15 

 

 
 

 

 

3  Tighten the module hold-down screws to secure the module in the lid.  Torque 

the screws from 25 to 30 in-lbs (2.8 to 3.4 Nm). 

 

Close the housing as follows. 
1  Ensure any worn gaskets are replaced, and the gaskets are clean and in the 

correct position. 

2  Carefully close the lid. 

 

CAUTION: 
Use caution when closing housing.  Improper closing may result in the Model 

GS7000 Node not being sealed from the environment. 

3  For strand-mounted housings, pull the lid away from the base and remove the 

slack from the hinge before rotating the lid up toward the base. 

4  Ensure no cables are pinched between lid and base. 
5  Secure lid to base with bolts.  Tighten from 5 to 12 ft-lbs (6.8 to 16.3 Nm) in the 

sequence shown in the following illustration.  Repeat the sequence twice, ending 
with the final torque specification.