Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Chapter 1 Introducing the Netcrypt Bulk Encryptor
18
4001444 Rev C
MPEG PN:
SPTS: Required. PN of incoming MPEG stream.
MPTS: Required along with the GDA to uniquely define an input
program. Entered into the DNCS at session-setup time
VOD Exclusive Sessions (always unicast SPTS)
Source UDP Port: Not used.
Source IP
Source IP
Address:
Optional: May be provided to the DNCS by the VOD server at session-
setup time
Destination UDP
Port:
Provided to the VOD server by the DNCS at session-setup time, per
SSP2.3
Destination IP
Address:
Provided to the VOD server by the DNCS at session-setup time, per
SSP2.3
MPEG PN:
Not required; usually set to zero
Netcrypt Bulk Encryptor Output Stream Addresses and Headers
Broadcast CFs or TSRs using unicast
Source UDP Port: Not used.
Source IP
Source IP
Address:
The IP address of the selected Netcrypt Bulk Encryptor output port
Destination UDP
Port:
SB-QAM: Uniquely defines an SPTS stream
Note: Along with a PN, this identifier defines a program within the
Note: Along with a PN, this identifier defines a program within the
MPTS stream.
TB-QAM: Selected by the DNCS from the QAM mapping table in
order to achieve the required RF carrier, PN, and PIDs at the output
of the QAM
Destination IP
Address:
IP address of the GbE port on the destination QAM modulator
Broadcast CFs or TSRs using Source-Specific Multicast (SSM)
Source UDP Port: Not used.
Source IP
Source IP
Address:
The IP address of the selected Netcrypt Bulk Encryptor output port
Destination UDP
Port:
Entered into the DNCS at session-setup time. Not required to identify
stream
Destination IP
Address:
The GDA. Entered into the DNCS at session-setup time
Broadcast CFs or SRs using any-source multicast
Source UDP Port: Not used.
Source IP
Source IP
Address:
The IP address of the selected Netcrypt Bulk Encryptor output port