Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Record the MAC Addresses
4001444 Rev C
31
Record the MAC Addresses
This section contains instructions for recording the MAC and GbE addresses so that
you or your system administrator has easy access to this information. These
addresses are needed to provision (configure) the Netcrypt Bulk Encryptor on the
DNCS.
Locating the MAC Address
A label similar to the following example is on the underside of the Netcrypt Bulk
Encryptor and contains the MAC addresses. As this example shows, each MAC
address contains 12 characters.
Recording the MAC Address
Follow these steps to record the MAC addresses so they are readily available to
provision the Netcrypt Bulk Encryptor on the DNCS.
1 If you have not already done so, unpack and inspect the Netcrypt Bulk
1 If you have not already done so, unpack and inspect the Netcrypt Bulk
Encryptor. Refer to Unpack and Inspect the Netcrypt Bulk Encryptor (on page
2 Locate the label containing the MAC addresses on the underside of the Netcrypt
Bulk Encryptor chassis.