Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Chapter 2 Installing the Netcrypt Bulk Encryptor
36
4001444 Rev C
Connect an AC Power Source
This section contains instructions for connecting an earth ground and an AC power
source to the Netcrypt Bulk Encryptor.
WARNING:
Invisible laser radiation may be emitted from disconnected fibers or
Invisible laser radiation may be emitted from disconnected fibers or
connectors. Do not stare into the laser beam or view the beam directly with
optical instruments. Doing so may pose an eye hazard.
Connecting an Earth Ground
Important: Make certain to allow enough cable length to be able to slide the
Netcrypt Bulk Encryptor out of the rack for repairs. Sufficient cable length allows
you to make some repairs without powering off the unit and disrupting services to
customers.
Follow these steps to connect an earth ground to the Netcrypt Bulk Encryptor.
1 Place a ground wire onto the ground lug (marked GND) on back of the Netcrypt
Follow these steps to connect an earth ground to the Netcrypt Bulk Encryptor.
1 Place a ground wire onto the ground lug (marked GND) on back of the Netcrypt
Bulk Encryptor; then, use your fingers to tighten the ground lug to secure the
ground wire.
2 Connect the other end of the ground wire to the rack or earth ground.
Connecting an AC Power Source
Important: Make certain to allow enough cable length to be able to slide the
Netcrypt Bulk Encryptor out of the rack for repairs. Sufficient cable length allows
you to make some repairs without powering off the unit and disrupting services to
customers.
Perform the following steps to connect a power source to the Netcrypt Bulk
Perform the following steps to connect a power source to the Netcrypt Bulk
Encryptor.
1 Verify that the power switch on the back of the unit is placed in the Off position.
2 Connect the power cord to the power inlet on the back of the unit.
3 Connect the other end of the power cord to an AC electrical outlet.
4 Keep the power switch in the Off position until you are ready to power on the
1 Verify that the power switch on the back of the unit is placed in the Off position.
2 Connect the power cord to the power inlet on the back of the unit.
3 Connect the other end of the power cord to an AC electrical outlet.
4 Keep the power switch in the Off position until you are ready to power on the
unit.
5 Now that you have connected the power source to the unit, you are ready to
begin connecting the ETHA Ethernet port. Go to Connect the ETHA Ethernet
Port for DNCS Control (on page 37).