Cisco Headend System Release 2.7 Installation Guide
Add a PCG
4017650 Rev C
49
Maximum streams allowed on the PCG
Name of the headend containing the PCG
The Control Word Provision Message Delay (in seconds)
The Nominal Crypto period duration (in seconds)
The SCG Provision Timeout (in seconds)
Note: All this information should be recorded for setting up the PCG with any third-
party SCS devices. However, if it is not, contact your system administrator to obtain
the information.
party SCS devices. However, if it is not, contact your system administrator to obtain
the information.
Setting Up PCG Provisioning Parameters
Be sure to allow yourself adequate time to complete this procedure. Adding a PCG
takes approximately 30 minutes. Complete the following procedure to add a PCG to
the DNCS.
takes approximately 30 minutes. Complete the following procedure to add a PCG to
the DNCS.
Important: Verify that you have gathered all of the information identified in the
previous section Before You Begin (on page 48).
1 On the DNCS Administrative Console, click the DNCS tab, and then click the
previous section Before You Begin (on page 48).
1 On the DNCS Administrative Console, click the DNCS tab, and then click the
Network Element Provisioning tab.
2 Click PCG. The PowerKEY CAS Gateway window opens.