Cisco Headend System Release 2.7 Installation Guide
Chapter 12 Obtain DHCT Information with the tellDhct Utility
146
4020695 Rev C
Display Conditional Access Information
The information in this section describes how to use the tellDhct utility to display
conditional access information for DHCTs.
conditional access information for DHCTs.
Displaying Conditional Access Information
Follow these instructions to run the tellDhct utility to display conditional access
information for a single DHCT or a list of DHCTs.
information for a single DHCT or a list of DHCTs.
Note: Refer to Display Formatting Details for the tellDhct Utility (on page 143) for
a detailed description of the fields displayed in the output.
1 If necessary, open an xterm window on the DNCS.
2 Choose one of the following options:
a detailed description of the fields displayed in the output.
1 If necessary, open an xterm window on the DNCS.
2 Choose one of the following options:
To display conditional access information for a single DHCT, go to step 3.
To display conditional access information for a list of DHCTs, go to step 4.
3 Type tellDhct [MAC address or SMSN] and then press Enter. The system
displays conditional access information for the DHCT.
Note: Substitute the MAC address or SMSN of the DHCT for [MAC address or
SMSN].
Example: tellDhct 00:01:A6:5B:D5:56
Note: Substitute the MAC address or SMSN of the DHCT for [MAC address or
SMSN].
Example: tellDhct 00:01:A6:5B:D5:56