Cisco Headend System Release 2.7 Installation Guide
Common Download
78-4036705-01 Rev D
115
Common Download
Configure the Carousel
Follow these steps to configure Common Download on the DNCS and DTACS
Servers.
Servers.
Important:
Refer to the DTACS Online Help for detailed information to complete these
configuration tasks.
configuration tasks.
Refer to Recommendations for Data Carousel Rate Management Technical Bulletin
(part number 716377) for guidelines on managing inband and out-of-band data
carousel rates.
(part number 716377) for guidelines on managing inband and out-of-band data
carousel rates.
1 On DNCS Source List UI, create a New Source for the DTACS Carousel
(dataPump).
Example: Name = DTACS CDL Carousel, Source ID = user specified Source ID
number (i.e., 310).
Example: Name = DTACS CDL Carousel, Source ID = user specified Source ID
number (i.e., 310).
2 Select a DTA GQAM and one of its outputs, which has sufficient bandwidth for
modulating the DTA images out to the DTAs.
Notes:
Notes:
If a DTA GQAM has not been defined on this system, or if another GQAM is
needed because of bandwidth issues, then create a new DTA GQAM using
the DNCS QAM List for support of the DTACS dataPump's session.
needed because of bandwidth issues, then create a new DTA GQAM using
the DNCS QAM List for support of the DTACS dataPump's session.
This example describes a DTA CDL Carousel configuration with a multicast
session. A unicast session may be used, but the unicast session setup is not
shown at this time.
session. A unicast session may be used, but the unicast session setup is not
shown at this time.